WalzCraft offers Finger and Hand Pull Rout Options for cabinet doors and drawer fronts, which eliminate the need for decorative handles / pulls, if not desired. This is a common addition to Contemporary slab style cabinet doors and drawer fronts where the intended design is for a simple, clean look.
Hand Pull Rout Availability
Hand Pull Routs are available on nearly any door style, and also with Model B & Model D Appliance Panels. The HR100, HR200 & HR300 are the available Hand Pull Rout Options, which are are applied to the face of the product. When ordering, it is necessary to specify the Rout Option and whether the Hand Pull Rout should run the Full Length (FL) or Not Full Length (NFL) of the product. Your product may also require special stile part sizes in order to accommodate the Hand Pull Rout.
The HR400 & HR500 Hand Pull Rout Options create a relief cut that allows additional space behind decorative hardware such as handles / hand pulls. It is necessary to specify the placement of this Hand Pull style as shown in our catalog specifications above.
Finger Pull Rout Availability
The FP100 & FP200 Finger Pull Options are applied to the back side of a door or drawer front and can run the full length of the product or in a 5″ wide option. It is necessary to check our Outside Edge Compatibility Chart under the Technical Information tab to ensure that the Outside Edge Profile of your choice is compatible with the Finger Pull Option chosen.
Finger Pull Rout Options can also be applied to the face of your product in the FP300 or FP400 option, where the rout runs a 5″ width in your choice of placement.