Additional Information
Standard Passageway Door Part Sizes
- Left or Right Stile: 4 1/2″
- Top Rail: 4 1/2″
- Shaped Top Rail: 4 1/2″ (at the narrowest point)
- Bottom Rail: 9″
- Lockset Rail: 8″ (noted “LSR” in our online catalog drawings)
- Other Center Rails: 4 1/2″
- Center Stiles: 4 1/2″
*Passageway Door Part Sizes can be specified beyond the listed standard part sizes above; however non-standard part sizes may have an additional charge.
Custom Design Requests
All custom design requests may be submitted by contacting our Customer Support Team for assistance.
Finishing
Passageway Doors can be ordered Unfinished or Prefinished. WalzCraft will prefinish all four edges and both sides of doors. It is important to refinish any edges that will be cut off, sanded, or planed during installation.
Hardware & Installation:
Passageway Doors are not machined for any hardware. WalzCraft does not currently offer prehung (to a frame) Passageway Doors; however, Door Jamb Stop Molding is available in a variety of options to allow for building door frames on-site.
Warranty
WalzCraft does warranty Passageway Doors up to and including 80″ in height. Passageway Doors have an allowable warpage tolerance of 1/4″.
Please note that Interior Passageway Doors are not intended for exterior use, nor are they fire-rated. No warranty when doors are installed outdoors. This includes entryway doors even when there is a storm door planned/scheduled to be installed. A consistent interior climate must be maintained on both sides of the door.
Interior Passageway Doors
All Interior Passageway Door Styles are available with raised, flat, or varying raised & flat Center Panels (between the front and back sides). Thicknesses offered range from 1 1/4″ up to 2 1/2″.
All Traditional & Old World Mortise & Tenon Stile & Rail profiles can be specified, with compatibility varying by door thickness chosen. Applied Molding can be incorporated into your design, while it should be noted that some doors may have special clearance considerations to account for depending on hardware being used. All Center Panel profiles are compatible, while the only Outside Edge profile available is the D7 (squared) edge.